4/16/2023 0 Comments Torguard detection failed![]() * How can this occur? "kernel: br0: received packet on eth1 with own address as source address". Is that true? If not, how to get rid of them? * torguard says that the various warnings and HMAC auth fails are nothing to worry about. Why? On each occasion openvpn just logs "Closing TUN/TAP interface" without any explanation. ![]() I finally rebooted the router at 09:08:18 this morning. Yesterday evening the VPN appeared to be flaky and finally failed at 00:24:16. How can I make openvpn try to connect again automatically? I tried "auth-retry no interact" but this didn't work and just went into an endless loop ![]() * When the openvpn client fails to connect then it just exits and the router continues with the ISP supplied IP. * Which changes can I make to the openvpn client config to help debug these connectivity issues? And then I rebooted again and everything worked as expected. It failed again when I rebooted the router. And since no new scripts have been installed on the router then surely there is no reason for the un-updated scripts to fail? What happened was the following: The VPN auth failed. As a software developer with over 30 years experience then I'm not sure that I can agree with this advice. They recommend changing the password to a less complicated one because some scripts don't like special characters. I talked to torguard about it and they said they have a copy of my password and their automated test system says that they can use the password to log into my account and therefore the problem must be on my side. Often the service works for 1 or 2 weeks at a time without issue. I have an always on VPN connection to the torguard service via my Netgear R7000 router running DD-WRT.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |